Connect to a Teradek encoder

The Teradek Cube, a wireless solution for encoding live video, can deliver live steams to the Wowza Video™ service. When you choose Teradek as your video source, Wowza Video generates a connection code as well as a configuration URL, either of which you can use to easily connect the Cube encoder to Wowza Video.

Note: Teradek Cube firmware 7.3.4 or later is required. After updating your Cube firmware, perform a hard reboot of the device to ensure compatibility with Wowza Video.

Teradek Cube encoders

Connect using the connection code

1. On the Live Streams page of Wowza Video, select the live stream that uses Teradek as its video source.
    
2. On the Overview tab of the live stream detail page, make note of the six-digit Connection code.
3. Log in to the Cube web interface, and click Video Stream Output.
4. On the Primary tab, click the Mode menu and choose Internet Streaming.
5. In the Provider menu, choose Wowza.
6. Under Mode choose Cloud.
7. Enter the six-digit Connection Code from Wowza Video and then click Connect.
    
8. Click Apply at the top of the Video Stream Output page.
9. Configure any other required settings for your broadcast in the Cube web interface.
    

Connect using the configuration URL

1. On the Live Streams page of Wowza Video, select the live stream that uses Teradek as its video source.
    
2. Click the Video Source and Transcoder tab of the live stream detail page.
    
3. Select the Configuration URL and copy it.
4. Log in to the Cube web interface and click Video Stream Output.
5. On the Primary tab, click the Mode menu and choose Internet Streaming.
6. In the Provider menu, choose Wowza.
7. Under Mode, choose Server.
8. Click Load Configuration.
9. Paste the shortened configuration URL that you copied into the Config URL field and then click Load.
10. Click Apply at the top of the Video Stream Output page.
     
11. Configure any other required settings for your broadcast in the Cube web interface.